Para quem já andou a ver a instruções dos módulos MILS, certamente que já devem ter verificado a existência de "assinaturas"
tal como é referido nas instruções originais, como se transcreve:
http://www.abellon.net/MILS/How do you build a BTU (BTM or CTM module)?
All the modules are built over baseplates, these baseplates have to achieve 32x32 size, no matter how many baseplates you use, but the size of 32x32 studs is mandatory. This can be achieved with one 32x32 baseplate, 2 16x32 baseplates, 4 16x16 baseplates and so on. When you have your 32x32 surface, you must keep in your mind that 2x2 studs on every corner are reserved to put an identification colour, made with a 2x2 brick or any other bricks you can put there, is not mandatory, but it is recommended to avoid confusion about the ownership of different modules in a common display. Then, two 1x4 technic bricks are placed in one of each side of every corner. The rest of the sides can be completed as their owners want. Over these parts a surface made with plates gives the final height of a standard MILS module: 1 baseplate plus 4 plates. In the rest of the module there is no limit to put bricks or other pieces to act as a support for the plates in the top of the module.
Como se refere, trata-se do espaço 2x2 no canto de cada baseplate, não sendo de utilização obrigatória, mas apenas e só para distinguir os vários módulos idênticos, no caso, módulos de linhas ferroviárias ou módulos de pista do MPL-i.
Sendo assim, venho propor, sem qualquer carácter obrigatório, para quem tenha ou venha fazer módulos MILS, que indique qual a sua assinatura que usa ou venha a usar nos módulos MILS.
===============
Lista de assinaturas:
AGarcia:
CyberX:
António Carvalho:
JMCampos:
nunofilipe72:
Jollyroger:
Conchas:
BAndy: